- Slicer : PrusaSlicer recommended
- Infill type : Gyroid recommended
- Support : No
- Brim : No
- Detect thin walls : No
- Perimeters width (internal and external) : 0.45mm
| Part | Quantity | Layer Height | Infill | Perimeters | Top/Bottom Layers | Filament type | Color |
|---|---|---|---|---|---|---|---|
| cable_guide_back_a | 1 | 0.20mm | 20% | 4 | 5 | PETG | |
| cable_guide_back_b | 1 | 0.20mm | 20% | 4 | 5 | PETG | |
| extruder_body | 1 | 0.20mm | 20% | 4 | 5 | PETG | Black |
| extruder_cover | 1 | 0.20mm | 20% | 4 | 5 | PETG | |
| extruder_idler | 1 | 0.20mm | 20% | 4 | 5 | PETG | |
| filament_sensor_cover | 1 | 0.20mm | 20% | 4 | 5 | PETG | Black |
| filament_sensor_lever | 1 | 0.20mm | 20% | 4 | 5 | PETG1 | Black |
| hotend_collet_clip | 1 | 0.20mm | 20% | 3 | 5 | PETG | |
| nozzle_fan_duct | 1 | 0.20mm | 20% | 3 | 5 | Read note2 below | |
| ptfe_cutter_50mm_60deg | 1 | 0.20mm | 20% | 3-4 | 5 | PETG | |
| x_carriage | 1 | 0.20mm | 20% | 4 | 5 | PETG | |
| x_carriage_back | 1 | 0.20mm | 20% | 3 | 5 | PETG | |
| x_end_idler | 1 | 0.20mm | 20% | 4 | 5 | PETG | |
| x_end_idler_tensioner | 1 | 0.20mm | 20% | 4 | 5 | PETG | |
| x_end_motor | 1 | 0.20mm | 20% | 4 | 5 | PETG |
Note1: Avoid eSUN PETG as some user reported that it might not block IR signal correctly. No other PETG have been reported to have this issue yet.
Note2: The nozzle_fan_duct needs to be printed with a heat resistant filament like ABS, Extrudr GreenTec Pro, annealed HTPLA, PC and probably much more. Don't forget to compensate for shrinkage accordingly to the filament type you are using.